Posted by6 months ago
Press the SkyBell button in and hold it for about a minute. The LED will flash rapid green red and green blue yellow. Once you see the LED flash yellow, please release the SkyBell button. During this time, please delete the SkyBell device from within the SkyBell app. After about a minute your SkyBell will default to sync mode. Release the button and wait while the doorbell resets. The light ring will go through a series of colors during the reset. This takes about 2 minutes. The doorbell will announce when the reset is complete, and the light ring will be pulsing green.
Archived
I recently bought a skybell hd from ebay said it is functional. But soon as I installed it (it is a mechanical ical door chime so installation is straight forward) the lights came on top was red for a second or two then steady green and the button remains steady green from the get go, I tried holding the button for longer than a minute and during f this ot seems the system rebooted but I couldn't get to the flashing green and red. When the unit 'reboots' all lights turn off then again button green and top red for about 2 seconds then steady green. I tried to reset it for about 4 or 5 times but no luck. Any one know any other way to reboot it. Other than that seems functional because sometimes all the lights are off and seems when motion is detected it lights turn green again (steady green). And not sure why it is green because it is not compact to much network. Also if it is not setup would it make the doorbell ring when the button pressed because when I press the button nothing happens. But it is getting power I check the wires ot OS around 21vac and the pins do make contact.
Thank you in advance
4 comments